Programming FTDI devices

From Tučňák Wiki
Revision as of 06:42, 4 April 2012 by Ok1zia (talk | contribs)
Jump to navigation Jump to search

This page describes how to programm the FT232R chip for use in:

You need File:MProg3.5.zip (obsoleted by FT_Prog but always work.

Run MProg

MProg initial state

Disconnect all possible USB devices (can contain FTDI chip also). Connect your device with FT232R. Press Ctrl+N to create new programming template. Press Ctrl+C to scan. MProg responds in bottom box:

Number Of Blank Devices = 0
Number Of Programmed Devices = 1

Change:

  • Device Type to FT232R
  • USB VID/PID to Own VID & PID
  • Vendor ID to A600
  • Product ID by table bellow
  • Manufacturer to OK1ZIA
  • Product Description by table bellow
Device Product ID Product description
Davac4 E110 Davac 4.x
Rotar4 E112 Antenna rotator 4.x
USBIO E113 USB GPIOs
HDKEYB E114 HD44780 + Keyboard


Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm.

In bottom box result appears:

Programmed Serial Number : FTVCZQUP
MProg device programmed

Replug the device. Run Control Panel and you'll see new device:

Control panel with new device