Edit QSO

The dialog for editing a QSO opens from the QSOs window: select the QSO and press <ENTER>. The dialog does not check the values you write.
You can change callsign, RST received, received QSO number, exchange, locator, mode, RST sent, date, time, operator, remark and phase. The sent QSO number and the frequency (QRG) are only shown, you cannot change them here. Callsign, RST, exchange and locator are saved in upper case. Time can be written as hhmm, hh:mm or hh.mm.
If you change one or both RSTs and do not change the mode, Tucnak sets the mode from the length of the reports: a 3-digit report means CW, a 2-digit report means SSB. In other cases the mode stays as you set it.
Option Error marks the QSO as a bad QSO. Tucnak counts zero points for it and it is not used for multipliers or for the duplicate check. In the EDI file the QSO is written with callsign ERROR. You can turn the QSO back to valid by clearing the option.
Item Phase is for contests with more phases. You can work the same station in the first and in the second phase, and in the second phase it is not a duplicate.
Option QSL promised marks that a QSL was promised for this QSO.
After you press OK, Tucnak recalculates the statistics and sends the changed QSO to other Tucnaks in the network.