Network & trace

From Tučňák Wiki
Jump to navigation Jump to search
Network & trace options

In this dialog (Setup -> Network & trace) you set the connection of Tucnaks in a Network and the tracing for debugging. After you press OK, Tucnak reads the network interfaces again and connects to the remote Tucnak again.

Enable remote connect - normally, if all Tucnaks are on a local network, leave this unchecked. Remote connect allows you to connect to a Tucnak over the internet. You can publish information here using the HTTP server. Beware of creating loops! Tucnak does not detect loops, it uses flood routing, so messages will cycle over the network infinitely.

Remote host name - host or IP address of the remote Tucnak.

Remote TCP port - TCP port of the remote Tucnak. Normally 55555.

Remote password - the password must be the same on both Tucnaks of the remote link. It is not sent over the network in plain text. The password is saved in the file tucnakrc in plain text.

Ignore interfaces - the list of the names of network interfaces which are ignored when Tucnak searches for other instances of Tucnak on the network (it sends broadcasts), for example the connection to the Internet or a public IP address from the provider. The delimiter between the items is a space, a tab or a comma. Broadcasts load slow networks.

Ignore networks - the purpose is the same as of Ignore interfaces. You specify the networks by their broadcast address (for example 192.168.1.255). The delimiter is a space, a tab or a comma.

Announce to nets - it is the inverse function of the previous items. Here you specify the IP addresses where Tucnak sends the broadcasts in addition. Routers usually do not forward broadcasts. The delimiter is a space, a tab or a comma.

Trace ... - for debugging you can turn on tracing of some kinds of events: broadcasts, sockets, received data, sent data, QSOs, rotars, rig and keys. The trace is written to the Log window. When you switch on a trace which was off, Tucnak opens the Log window. The items Trace rotars and Trace rig have three states: off, basic and detailed (with the messages of the threads of the rig and the rotator).

Tracing slows Tucnak down and fills the log, use it only when you look for a problem.