Band defaults
Jump to navigation
Jump to search

This submenu contains the settings of all bands. The active bands (QRV on this band is checked) are separated from the other bands. You can take away the bands which are never used (as 220 MHz in Europe).
You can enter the setting of a single band by pressing the ENTER key. The item QRV on this band is usually set for all bands where you are allowed to transmit.
This setting is the only one which must be set. The other items are better set here too, but it is not necessary.
The band settings are the defaults. When you create a new contest, Tucnak copies them to the contest (see New Contest). The dialog of a band in an opened contest (menu Contest -> Contest options) has fewer items and changes only this contest.
- QRV on this band - you are able to work on this band. Only these bands are in the list of bands.
- QRV in this contest - the band is used in the next contest which you create. You can also change it in the dialog of the new contest.
- Read-only - the band is read-only, no QSO can be written to it. See Bands.
- Category - one of Multi/Single/Check. If you select Other, you can enter an arbitrary category in the field next to it, for example 1L, 1H... for NAC.
- TX Equip, RX Equip, Power, Antenna, AGL;ASL - the description of the equipment. Power is written with units. ASL and AGL mean the height of the antenna above sea level and above the ground. The values are in meters, the delimiter is a semicolon.
- Operators - callsigns of the operators, delimited by a semicolon. You can fill it also by Fill operators in the menu Contest. There are two lines for longer lists.
- Remarks - remarks to the contest committee.
- Single category in OK, Multi category in OK - the codes of the categories valid (probably) only in the Czech Republic. They are used mostly for the names of the EDI files.
- Band boundary from ... to [kHz] - the band boundaries are entered in kilohertz. They are used for the filtering of the DX cluster spots and for checking that the frequency of the rig belongs to the band.
- ADIF band name - the band description used in the ADIF format.
- QRG for skeds - the initial frequency which you enter to inform other operators about the clean/CQ frequency on which they should take skeds. The format is not limited, you can use any string like ".120" etc. See QRG for skeds.
- Transverter's LO QRG [Hz] - the frequency which Tucnak adds to the frequency read from the CAT of the transceiver and the result is shown on the screen: fdisplay = fCAT + fLO (all in Hz).
- Note that some radios support the transceiver mode, for example the radio is tuned to 14 MHz, CAT reports also 14 MHz but the display of the transceiver shows 144 MHz.
- The LO frequency must be computed by the operator, you can use Fix QRG in the Edit menu.
- This is the local frequency for one band. Normally enter 0 to use the Global LO frequency.
- Band switch value - the value (a hexadecimal number) which is sent to some keying devices to inform your contest hardware about the active band in Tucnak.
- Stats WWL radius - the radius of the map of the locators in the Statistics window, counted in large squares. The map is 2 x radius + 1 squares wide.