CW CQ

From Tučňák Wiki
Jump to navigation Jump to search

After you select this item (Setup -> CW CQ), Tucnak shows the list of all CW messages (CQ 0 to CQ 7). Every line has the number of the message, the key which runs it (see Hotkeys), the character R if the message is repeated (CQ) and the beginning of the text. Select a message to edit it.

CW CQ

The messages CQ 0 to CQ 3 run by F5 to F8, CQ 6 and CQ 7 by F11 and F12. The keys F9 and F10 (CQ 4 and CQ 5) open the menu. In the dialog of CQ 4 there is a check box Use F9 for CQ instead of the menu and in the dialog of CQ 5 a check box Use F10 for CQ instead of the menu. If you check it, the key runs the message and the menu is not opened by this key. The messages 0, 1 and 2 are also used by the Run mode.

There are these items in the dialog for setting a CQ:

Text of the CQ. You can use plain text and macros, see CQ macros.

Speed [WPM] is normally 0 (not defined, the speed from CW keying is used) but you can define the speed only for this CQ (f.e. for fast 73).

Repeat - the CQ will be repeated until you press ESC, TAB or another CQ key.

Breakable - the CQ is interrupted when the operator writes to the main input line.

Delay [s] determines the time between the repeated CQ messages (0 to 120 seconds, default 3). Tucnak counts it from the end of the message, so it is the pause between two messages.

With the keying by Hamlib the radio does not tell Tucnak when it has finished the message. Tucnak repeats the CQ blindly and counts the Delay from the beginning of the message, so the Delay is the length of the message plus the pause. Set it longer than the message, otherwise Tucnak starts the next message before the radio has finished the first one.

Allow if some item is undefined allows to run the message even if some macro in it has no value. Typically you do not want to send an empty string if you have no callsign entered, so leave it unchecked.